Configuring VPLS on a Border VTEP To configure VPLS on a border VTEP, in the software configuration guide for the required release, see Contents Multiprotocol Label Switching (MPLS) Configuration Guide Configuring Virtual Private LAN Service (VPLS) and VPLS BGP-Based Autodiscovery . Configuration Examples for EVPN VXLAN External Connectivity The following section shows the configuration examples for EVPN VXLAN external connectivity to other technologies: Example: Enabling Layer 3 External Connectivity with MPLS Layer 3 VPN through iBGP This section provides an example to show how Layer 3 external connectivity with MPLS Layer 3 VPN is enabled for a BGP EVPN VXLAN fabric through iBGP.
The example shows how to configure and verify Layer 3 external connectivity with MPLS Layer 3 VPN for the topology shown below: Configuring EVPN VXLAN External Connectivity Configuring VPLS on a Border VTEP Command or Action Purpose Step 4 member access-vfi vfi-name Example: Device(config-vlan)# member access-vfi myVFI Adds the access VFI as a member of the VLAN configuration. Step 5 member evpn-instance evpn-instance-number vni l2-vni-number Example: Device(config-vlan)# member evpn-instance 1 vni 6000 Adds the EVPN instance as a member of the VLAN configuration. Step 6 end Example: Device(config-vlan)# end Exits VLAN configuration mode and enters privileged EXEC mode.
Configuring EVPN VXLAN External Connectivity 20