Screen Specifications 13 EtherNet/IP Screen EtherNet/IP devices that connected to NA’s Ethernet ports are detected and displayed on this screen. 2 3 4 5 6 1 7 8 10 9 13 11 14 16 12 15 User I/F Specifications No Part Description 1 Group The information of a device is shown. Refer to No. 9 and later for details. 2 DropDown You can select an NA port. Port 1 is selected by default. Devices connected to the selected port are displayed. 3 Button Reads the configuration out. 4 Button Lamp Displays a check result of the actual and registered configurations.
When no configuration is registered, displays “Not registered.” Touched when the result is “Mismatch”, the screen switches to the Network Configuration Mismatches Window. 5 Button Enables to go to Network Configuration Registration Window. 6 Button Enables to go to Filtering Window. 7 Group Appears when the button No.３ is pressed. The dialog “Reading configurations” blinks. 8 Button Enables you to go to the previous network configuration page. Available for 32 and more devices. 9 Button Enables you to go to the next network configuration page. Available for 32 and more devices. 10 Lamp Indicates pages for devices connected to the network.
The same numbers of white lamps as pages are displayed. A gray lamp indicates the page currently displayed. Red lamps are for expansion and not shown in the actual NA. 11 DataDisplay Unit model is displayed. 12 DataDisplay Unit’s IP address is displayed. 13 Lamp Indicates if the unit is included in the DLR configuration. The indication switches to Ring Super Visor (DLR R-SV) or Ring Node (DLR RN). 14 Lamp Indicates a failure of the unit. Supports only GI-S Units. 15 Lamp Indicates a failure in the network. Supports only GI-S Units. 13 14 15