Screen Specifications 14 IO Status Screen Displays the information of the IO-Link master unit whose IP address is notified externally. 1 2 3 4 5 6 7 5 6 7 8 9 10 11 12 13 No. Part Description 1 DataDisplay IP address of the selected device is displayed. 2 Group Unit status is displayed. Refer to No. 8 and later for details. 3 Button The LED that indicates the location of the IO-Link master unit on the screen is lit when this button is pressed. It is for expansion and not shown in the actual NA. 4 Button Displays Device Information Window. 5 DataDisplay Displays pin modes of Pin4 (upper) and Pin2 (lower) for each IO port as the following. Pin4: Any of Disabled, DI, DO, or IO-Link Pin2:
Any of Disabled, DI, or DO 6 Button WordLamp Displays statuses of Pin4 (upper) and Pin2 (lower) for each IO port as the following. Pin4: Any of Disabled, ON, OFF, Communicating with IO-Link Unit, Error in IO-Link Unit, Short circuit detected, or Not connected. Pin2: Any of Disabled, ON, OFF, Short circuit detected, or Not connected. Pressing the Pin4 button when Communicating with IO-Link Unit or Error in IO-Link Unit is being displayed executes the event ShowPortStatusEvent. 7 Button Connected device name is displayed only when the pin mode is IO-Link; otherwise, “-” is displayed. Executes events for connected devices. For NXR-D Series Units, the event SelectNXR D SeriesEvent is performed.
8 Lamp _ _ Unit status is displayed. 9 Lamp Network condition is displayed. 10 Lamp Displays EtherNet1 port condition. 11 Lamp Displays EtherNet2 port condition. 12 Lamp Displays the condition of the input power supply voltage. 13 Lamp Displays the condition of the output power supply voltage. 4 7 5 6 7 8 9 10 11 12 13 5 6