Paint treatment PAINT TREATMENT ΞΦ95 series 0 1.3 RESPRAYING/PAINT REPAIRING CHASSIS FINISHING 1. Remove any preserving agents, if applicable; see "General operations". 2. Remove any rust with a rust-removal agent. 3. Clean the area to be treated with solvent. 4. Sand the area to be treated with P80 sand paper. 5. Remove any dust from the sanded section with a Tack-rag cloth. 3 6. Clean the area to be treated with solvent. 7. Apply primer to any bare patches. 8. Leave the primer to evaporate/dry. 9. If necessary, sand with P180 sand paper. Following sanding, remove any dust with a Tack-rag cloth and clean the area with a solvent. 10.
Apply the top coat according to the manufacturer's instructions. 11. Leave the top coat to evaporate/dry. Observe the drying time as laid down in the manufacturer's instructions. © 200651 1-5