PAINT TREATMENT Paint treatment ΞΦ95 series 0 1.4 RESPRAYING SEED TOP COATS These instructions relate to parts in steel, SMC (Sheet Moulding Compound) plastic or glass- fibre reinforced polyester. 1. Remove any preserving agents, if applicable; see "General operations". 2. Remove any rust with a rust-removal agent. 3 3. Clean the area to be resprayed with a solvent. 4. Sand the area to be resprayed first with P80 sand paper and then with P180 sand paper. 5. Remove any dust from the sanded section with a Tack-rag cloth. 6. Clean the area to be resprayed with a solvent. 7. In the case of plastic, blow ionised air over the area to be resprayed, or clean the area with an anti-static liquid. 8.
Apply the seed top coat according to the manufacturer's instructions. 9. Leave the paint to evaporate. 10. Observe the drying time as laid down in the manufacturer's instructions. 1-6 © 200651