DPO6000, MPO6000 Series Digital Fluorescent Oscilloscope Product Manual V1.3 Refers to measurement at the source of the low-voltage equipment. Examples are elec- tricity meters, measurements on major overcurrent protection devices, and measure- ments on pulse control units. Ventilation requirements The oscilloscope is forcedly cooled by a fan. Ensure that the intake and exhaust areas are free of obstructions and free-flowing air. To ensure adequate ventilation, when using the oscilloscope in a workbench or rack, ensure that there is a gap of at least 10 cm on its sides, above, and behind.
WARNING Poor ventilation will increase the temperature of the instrument and cause damage to the instrument. Good ventilation should be maintained during use. Regularly check the vents and fans. Working environment Temperature During operation: 0 ℃ to +50 ℃ Non-operating: -40 ℃ to +70 ℃ Humidity 0 ℃ to +30 ℃ : 95% relative humidity +30 ℃ to +40 ℃ : 75% relative humidity +40 ℃ to +50 ℃ : 45% relative humidity WARNING To avoid the danger of short circuit or electric shock inside the instrument, do not operate the instrument in a humid environment. Altitude When operating: below 3000 meters Non-operating:
below 15000 meters Daily maintenance and cleaning Daily maintenance When storing or placing the oscilloscope, do not expose the LCD monitor to direct sun- light for a long time. 4