2 Priority is given to supplying power to the load to ensure that the Suitable for lead-acid batteries, such as flooded, Gel, AGM, and so All-In-One Intelligent Security Power(Power supply,DC-UPS, equipment can operate normally（remaining power is used to temperature/Battery reverse polarity（ damaged）/Battery No Smart programmable charging parameters（with programmer Function option (Blank: - Modbus CAN: CANBus ) Built in , optional Signal and alarm with UL2524, , s design meet NFPA 1221 BS AC ail, DC OK, ow attery oltage, harging f L B V C fail detection available Universal input 90~305Vac with PFC (277Vac ) Built-in Modbus communication（Optional CANBus) Protection:
Short circuit/Over voltage/Over load/Over on, or lithium-ion batteries, such as lithium ion, lithium Output voltage (12V/24V/36V/48V) 20%~100% charging current adjustable by VR DEKRA/UL/EAC( Pending battery charger and status monitoring) EN and /EN54-4 GB17945 requirement -30~+70℃ temperature wide operating LED indicator: status/abnormal indication 2 or 3-stage by DIP S.W. selectable Rated wattage Series name 2 charge the battery） manganese, and so on. 2.1 Model number 3 years warranty 2. Introduction Form C relay under voltage 48 DRS 240 2 2 .
Features SBP-001） Risk of electrical shock and energy hazard.Allfailure should be examined by a qualified technician.Please do not remove the case of the power Risk of electrical arcs and electric shock(danger to life).Connecting both Risk of burn hazard.Do not touch the unit in operation and shortly after Risk of fire and short circuit.The openings should be protected from Please do not install the unit in places with high moisture or near the Before commencing any isstallation,maintenance or modification work:Disconnect your system from supply voltage.Make sure that For continued protection against risk of fire,replace only with same type a.
Make sure charging voltage and current meet battery s specification. ' c. The cables between power supply and battery should be kept as short as possible to prevent excessive voltage drop (suggested cable length: 50cm~ 1000cm). Too much voltage drop will lead to longer charging type, gel colloid type, AGM adsorption glass fibber) or (lithium ion, Note.1: Pollution Degree 2 applies where there is only non-conductive pollution that might temporarily become conductive due to occasional condensation.Generally refer to dry,well-ventilated d. The power supply is suitable for lead-acid batteries (flooded water Only install the unit in a pollution degree 2 environment(Note.1) .
the primary and the secondary sides together is not allowed . b. Refrain from connecting new and old batteries in series. The FG( )must be connected to PE(Protective Earth). inadvertent connection in circuit will be impossible. Disconnect system from supply voltage: lithium manganese, lithium ternary...etc. locations,such as control cabinets. foreign objects or dripping liquids . Notices for battery application 1 1. Safety Guidelines 1 supply by yourself . and rating of fuse. disconnection . period. water. 48