User Manual 2. Function Introduction This chapter provides some general information that you need to learn before using an oscilloscope. It contains: 2.1. Menu and Control Keys As shown in the figure below: All the keys are described as follows: Menu keys [SAVE/RECALL] : "Save/Recall" menu, to save and recall files such as waveforms and settings. [MEASURE] : “Measure” menu, to measure waveform parameters such as frequency and amplitude. [ACQUIRE] : Waveform “Acquisition” menu, to set waveform acquisition parameters such as acquisition mode, storage depth. [UTILITY] :
"Auxiliary function" menu, to view system information, perform system upgrades, self-calibration and other auxiliary functions. [CURSOR]: "Cursor" measurement menu, when using cursor measurement, you can use the [V0] knob to adjust the cursor position. [DISPLAY]: "Display Parameters" menu, to set the oscilloscope display parameters such as waveform brightness, grid type, and persist. Operation mode keys [AUTO SET]: automatically set the control state of the oscilloscope so as to display suitable waveform. [RUN/STOP]: continuously acquire waveform or stop acquisition [SINGLE SEQ]: Acquire a single trigger, finish acquisition and then stop. 13 / 67