DeviceNet Network Scanner DVPDNET-SL 9 Setup of Extended Baud Rate 9.1 Setup of Extended Baud Rate (as master mode) 1) Connect the device to the Devicenet network according to the following figure. PC accesses PLC MPU via RS232 or RS485. DVP28SV DVPDNET-SL DeviceNet Builder 2) Open DeviceNet Builder software and select “Setup” => “Communication Setting” => “System Channel”. And then the following dialog box appears. 3) Set up the communication parameters in the PC and DVP-SV, e.g. the communication port, address, baud rate and communication format. Click on “OK” after configuration is finished.
4) Select “Network” => "Online” and the following “Select Communication Channel” dialog box will appear. Click on “OK”. DVP-PLC Operation Manual 26 Item Function Default COM Port COM port on the PC to be used to communicate with DVP-SV COM1 Address Communication address of DVP-SV 01 Baud rate Communication speed between the PC and DVP-SV 9,600 (bps) Data Bits Parity Stop Bit Communication protocol between the PC and DVP-SV 7 Even Parity 1 Mode Communication mode between the PC and DVP-SV ASCII