Kendrion Kuhnke Automation GmbH CAM Creator 7 FIOCAM Creator This section describes how to operate the FIOCAM Creator. 7.1 Cam programming Once the application is up and running, you will see a table of cam programs on the left and the associated diagram - the CAM array - on the right-hand side of the screen. 7.1.1 Editing the cams The cam program programs displays as an editable table. (Refer to Project, Options, CAM to know more about the number of cams per track, the number of tracks per program, and the number of programs). (Refer to Project, Options, Encoder and ...CAM for resolution details) Decide whether to edit the cams as number of increments (ticks) or angular degrees.
(Changing between the two may produce non-integral values due to rounding differences.) • Enter the values into the correct cells. • Enable the tracks by ticking the boxes of the appropriate rows. Exports the cam programs to Excel sheets for documentation or reuse at a later time. Imports cam programs from Excel sheets you previously exported and edited, as appropriate. Enables/disables all cams Changes the cam settings online Kuhnke FIO CAM Control ( E 808 GB ) 28 11/10/2017