SAFETY FEATURES / ALARMS Intervention of one of the safety features interrupts the washing cycle (i.e. all loads are disactivated). One or two PROGRAMME LEDs light (flashing_ F V ) to indicate the type of alarm condition that has occurred. SITUATION: - Machine stopped - All control keys disabled. - LED La only lit.
SOFTWARE SAFETY SYSTEMS ALARM Time-Out for WATER FILL LED [ L 1 ] Time-Out for WATER REPLENISHMENT LED [ L 2 ] Time-Out for PRESSURE SWITCH "EMPTY" (wash) TEMPERATURE SENSOR OPEN/SHORT-CIRCUITED LED [ L 3 ] Time-Out for WATER HEATING LED [ L 4 ] Time-Out for PRESSURE SWITCH "EMPTY" (drain) LED [ L 5 ] MOTOR BLOCKED OR INTERRUPTED LED [ L 1 ] & [ L 2 ] RESETTING AN ALARM CONDITION - To reset the appliance after an alarm condition, press the ON/OFF key ( SW0 ). - When the ON/OFF key ( SW0 ) is again pressed, the appliance returns to the programme selection phase, and the cycle that has been interrupted can be repeated. - If the fault persists, the appliance returns to the ALARM condition.
In this case, it is necessary to call a service technician to solve the problem and restore the appliance to normal operating conditions, since the electronic control system will accept no settings. 15