Section 1 — Controls and Architecture 8) Pedal•CV This jack is for connecting an optional ENSONIQ Model CVP-1 Control Voltage Foot Pedal, which is assignable as a modulator to various parameters within the ASR-10. The pedal gives you a handy alternative modulation source when, for example, you would want to use the Mod Wheel but both hands are busy. ENSONIQ CVP-1 Control Voltage Foot Pedal A CV pedal plugged into this jack can also act as a Volume pedal, controlling the volume of the currently selected Instrument•Sequence Track(s) .
A parameter on the Edit/System•MIDI page (press Edit , then System•MIDI , then scroll until the display reads PEDAL=VOLUME MIDI=7), determines whether the CV pedal will act as a modulator or as a volume pedal. Set to PEDAL=VOLUME to use the CV pedal to control volume. Pedal/CV Specs: 3-conductor (Tip= control voltage input, Ring=510 ohm resistor to +5 Volts, Sleeve= ground). 36 KOhm input impedance, DC coupled. Input voltage range=0 to 3 volts DC. Scan rate=32mS (maximum recommended modulation input= 15 Hz). For use with an external control voltage, use a 2-conductor cable with the voltage on the tip and the sleeve grounded. Rear Panel Connections 3