2.7 Communication connectors and terminals 1 2.7.1 PU connector 2 Mounting the operation panel or the parameter unit on the enclosure surface 3 • Having an operation panel or a parameter unit on the enclosure surface is convenient. With a connection cable, the operation panel or the parameter unit can be mounted to the enclosure surface and connected to the inverter. Use the option FR-CB2[ ], or connectors and cables available on the market. 5 (To mount the optional LCD operation panel (FR-LU08), the optional connector (FR-ADP) is required.) Securely insert one end of the connection cable until the stoppers are fixed.
5 6 Parameter unit connection cable (FR-CB2[])(option) Parameter unit (FR-PU07) (option) Enclosure surface operation panel (FR-PA07) (option) PU connector 7 STF FWD PU 8 Operation panel connection connector (FR-ADP) (option) LCD operation panel (FR-LU08)(option) 9 10 • Refer to the following table when fabricating the cable on the user side. Keep the total cable length within 20 m. • Commercially available products (as of February 2015) Communication operation • Using the PU connector as a computer network port enables communication operation from a personal computer, etc.
When the PU connector is connected with a personal, FA or other computer by a communication cable, a user program can run to monitor the inverter or read and write parameters. Communication can be performed with the Mitsubishi inverter protocol (computer link operation). For the details, refer to page 163 . 41 2. INSTALLATION AND WIRING 2.7 Communication connectors and terminals NOTE Product Model Manufacturer Communication cable SGLPEV-T (Cat5e/300 m) 24AWG × 4P Mitsubishi Cable Industries, Ltd. RJ-45 connector 5-554720-3 Tyco Electronics