Right Cover 1 Remove the Vertical Transfer Unit (VTU) from the 2000-sheet Input Tray (see figure 6-76). 2 Remove the 2 screws that are located near the middle of the 2000-sheet Input Tray’s Right Cover: 1 screw on each side (figure 6-65, callout 1). 3 Using a flat-blade screwdriver, release the plastic retaining tab that secures the Right Cover’s upper-left corner to the chassis (figure 6-65, callout 2). 4 To remove the Right Cover, carefully pull out on the top of the cover while lifting it upward to clear the retaining tabs that are along the cover’s bottom edge. To Reinstall: 1 Place the retaining tabs that are along the Right Cover’s bottom edge over the chassis rail.
2 Reinstall the VTU (see figure 6-76). Figure 6-65 2000-sheet Input Tray Right Cover 236 Chapter 6 Removal and Replacement C4085-91087