Installation Procedure KX11 PHEV 2023 Engine Engine control system (DHE15-ESZ) 2-47 1 Install and tighten the air conditioning coolant temperature sensor (cylinder block). Torque: 15N·m Caution 1. It is prohibited to touch the part pins. 2. Electrical plugging or unplugging of part connectors is not permitted during energizing operations such as cold or hot test. 3. Avoid dropping parts or subjecting them to shocks. Dropped parts must be scrapped. 4. If replace the sensor necessarily with a new one, check that there is no obvious deformation or damage on the threads of the installation holes, and then install a new sensor according to the specified torque. 5.
If the sensor is reused, clean the residual glue inside the sensor mounting holes, check that the sensor gasket has no obvious damage and penetrating indentation, and that the sensor and its mounting hole threads have no obvious deformation or damage, and then tighten it in accordance with the specified torque after uniformly applying an appropriate amount of thread sealant on the sensor threads. 2 Connect the harness connector A of the air conditioning coolant temperature sensor (cylinder block). 3 Install the air filter intake pipe assembly. 4 Install the air filter assembly. 5 Install the engine trim cover assembly.