Table 37. Printer messages (continued) Control panel message Explanation Recommended action TRAY 1 SIZE = [xxxx] The printer is asking what size of media has been loaded in tray 1. In response, you can take either of the following actions: 1. Press S ELECT to accept the paper size. 2. Press -V ALUE + to change the size and then press S ELECT to accept the new size. The printer will first display the TRAY 1 TYPE = XXXX message (see the description of that message). If you do not press any buttons in the time-out period (about one minute), it displays this TRAY 1 SIZE = XXXX message. Changing the size here changes the default for tray 1 paper size in the paper-handling menu.
TRAY 1 TYPE = [xxxx] The printer has received a job under the three following conditions: You can take either of the following actions: 1. Press S ELECT to accept the paper type. 2. Press -V ALUE + to change the type and then press S ELECT to select the new type. Note Changing the type here changes the default for tray 1 media type in the paper-handling menu. If you do not do anything during the time-out period (about one minute), the printer will print on the media in tray 1. ! The media type requested by the job is not available in the printer. ! Tray 1 has been set for CASSETTE. ! Media has been placed in tray 1 (thus triggering tray 1’s paper sensor).
If you do not press any buttons, the message disappears in about one minute). UNABLE TO MOPY JOB Memory or file system failures would not allow a mopy job to occur. Only one copy will be produced. 1. Reseat RAM DIMMs and/or the EIO hard disk. 2. Install additional memory or an EIO hard disk. UNABLE TO STORE JOB Memory or file system failures would not allow the print to store the job. 1. Reseat RAM DIMMs and/or the EIO hard disk. 2. Install additional memory or an EIO hard disk. EN Chapter 7 Troubleshooting 205