3.1 Resistance measurement See the below figure for the connection test. 1. Press the power key to start the instrument. 2. Press the [AUTO/R/C/L/Z] key until Rs/Rp is displayed on the interface which means to select resistance measurement. 3. Insert the resistor into the test notch, or choose the appropriate test accessories (rubber plug - alligator clip) and connect it with the measured resistance. 4. Press the [FREQ] key to select the desired test frequency, press [LEVEL] to select the desired level. 5. Read the measurement results from the screen. Note:
the AC signal is used by the instrument to measure the resistance, so the test result reflects the AC resistance characteristics of the instrument instead of its DC resistance. 15