Start using EN 5 Start using ⚫ To prevent electric shock accidents, please do not short circuit the top of the test line and the line with voltage. ⚫ Do not measure AC voltage, AC current, or DC current. Otherwise, it may cause instrument damage or personal injury accidents. ⚫ To prevent electric shock, please confirm the rated value of the test wire before measurement, and do not measure voltage higher than the rated value. 5.1 Measurement Settings Click the [Range] button to enter the measurement display interface. Figure 5-1 Measurement display interface Note:
If no settings are made in other interfaces (except the calibration interface) for more than 30 seconds, the instrument will automatically jump to the measurement display interface. 5.1.1 Setting Type Click the Type menu soft key to select categories such as V&R, Voltage, and Resistance. V&R: Simultaneously measure and display voltage and resistance, as shown in Figure 5-1. Voltage: Measure and display the voltage value, as shown in the following figure. HBT3000 series user manual Copyright © Qingdao Hantek Electronic Co., LTD 20