32LD380TA Remote Control Install the batteries Use batteries type UM-4 (AAA-Size). Do not use the storage batteries. The remote control does not work properly with weak voltage from the storage batteries. Replace the exhausted batteries with new batteries. Never charge batteries. Batteries may explode by the charge. ENGLISH Note: An exhausted empty batteries may leak, namely corrosive electrolyte will leak out. The remote control may damage by it. Therefore remove the exhausted batteries early. 3 1 Open the battery compart- ment. Close the battery compartment. 2 Install the batteries as shown below. Distance of Remote Control Operation Point the remote control directly at the remote sensor.
Remote sensor 30 30 Maximum distance approx. 5m Transmitter window The remote control handset will not work properly in the following cases: If bright sunlight directly beams onto the unit front. If an obstacle is placed between the unit and the handset. Z Z Z Z Z Z If the batteries have not been installed according to their polarities. If the batteries are weak. 11 3V90441A [E] P09-12 31/10/05, 9:21 AM 11 HITACHI