Removal and Installation Right End Roll-Feed Removal WARNING Switch off the printer and remove the power cord. NOTE Refer to the table on Page 8-4 for information on screw types. 1. Remove the Right Hand Cover - Refer to Page 8-7 . 2. Remove the Spindle. 3. Remove 1 T-20 screw ( Type F ) from the Right Hand Roll-Feed. 4. Remove 2 T-20 screws ( Type F ) from the Right Hand Roll-Feed (located on the inside). 8-15 HP DesignJets 500 and 800 Series Printers Service Manual