Removal and Installation Installation of Carriage and Belt NOTE Before installation, clean and oil the Slider Rods using the User’s Slider Rods Lubrification Kit (Refer to the User’s Guide). WARNING Make sure you install the Carriage Assembly and Belt as follows: 1. Insert belt as indicated on the underside of Carriage. TIP An arrow on the bottom of the Carriage indicates position and direction. 2. Line up the Carriage Guide, on the underside of the carriage, with the Slider Rods on the Printer. NOTE Perform the following Service Calibrations after the installation of the Carriage Assembly: Carriage Height ⇒ Page 5-18 . Service Station ⇒ Page 5-11 . Scan Axis ⇒ Page 5-7 .
Printhead Alignment ⇒ User Guide. Color Calibration ⇒ User Guide. 8-52 HP DesignJet 5000 and 5500 Series Printers Service Manual