Removal and Installation 9. From the right-hand side, lift the Tensioner Belt off the Scan-Axis Motor. 10. While supporting the Scan-Axis Motor, remove 2 T-15 screws ( Type B ). 11. Lower the Scan-Axis Motor and remove from the Printer. Installation of the Scan-Axis Motor NOTE Before installation, clean and oil the Slider Rods using the User’s Slider Rods Lubrification Kit (Refer to Page 9-8 ). WARNING When installing the Encoder Strip, make sure it is inserted in the Encoder Sensor on the rear of the Carriage Assembly. 8-59 HP DesignJet 5000 and 5500 Series Printers Service Manual Insert Encoder Strip Encoder Sensor Note: When installing the Belt, make sure that it is not twisted.