RAM disk file system is full To clear press “OK” ......................................... 336 RAM disk is write protected To clear press “OK” ........................................ 336 RAM disk not initialized .......................................................................... 336 Ready ................................................................................................... 337 Ready ............................................................................... 337 Receiving Upgrade ................................................................................. 337 Remove one print cartridge .....................................................................
337 Remove USB accessory ........................................................................... 337 Replace .................................................................................. 338 Replace supplies .................................................................................... 338 Resend external accessory firmware ......................................................... 339 Resend Upgrade .................................................................................... 339 Restore Factory Settings .......................................................................... 339 ROM disk device failed To clear press “OK” .............................................
339 ROM disk file operation failed To clear press “OK” .................................... 339 ROM disk file system is full To clear press “OK” ......................................... 340 ROM disk is write protected To clear press “OK” ....................................... 340 ROM disk not initialized To clear press “OK” ............................................ 340 Rotating Motor ....................................................................................... 340 Size Mis-Match ...................................................................................... 340 Size mismatch in Tray ......................................................................
341 Sleep mode on ...................................................................................... 341 Staple Cartridge low .............................................................................. 341 Staple Cartridge very low ....................................................................... 341 Stapler/Stacker staple jam ...................................................................... 342 Supplies low .......................................................................................... 342 SUPPLY MEMORY WARNING .................................................................
342 The unit has corrupt data ......................................................................... 342 Tray empty: [Type], [Size] ................................................................ 343 Tray lifting ...................................................................................... 344 Tray open ....................................................................................... 344 Tray overfilled ................................................................................. 345 Type mismatch Tray ................................................................................
345 Unsupported drive installed To continue, touch “OK” .................................. 345 Unsupported supply in use OR Unsupported supply installed To continue, touch “OK” ........................................................................................... 346 Unsupported tray configuration ................................................................ 346 Unsupported USB accessory detected Remove USB accessory ...................... 346 Upgrade Error ....................................................................................... 346 USB accessory not functional ...................................................................
347 USB hubs are not fully supported Some operations may not work properly .... 347 ENWW xvii