2. Release one tab (callout 2), and then slide the SSM toward the hinge side of the door. TIP: It might be easier to remove the SSM if you separate the formatter cage door from the cage. Slide the door toward the top of the cage, and then separate the components. Figure 2-16 Remove the SSM (2 of 3) 2 3. Remove the SSM from the cage door. NOTE: Slide the SSM out of the mounting cradle to separate the components. Do not lose the cradle while handling the SSM. Reinstallation tip Use the cradle to install a replacement SSM. After installing a replacement hard drive, you must reload the firmware by performing a firmware upgrade. See Installing a replacement hard drive on page 78 .
Figure 2-17 Remove the SSM (3 of 3) ENWW Customer replaceable units (CRUs) 75