Top cover with LCD control-panel module 1. Remove the following components: ● Tray 2 cassette ● Right cover. See Right cover on page 12 . ● Left cover. See Left cover on page 11 . 2. Open the toner cartridge door and the rear jam access door. 3. On the left side of the product, disconnect one flat cable (callout 1) from the formatter. Figure 1-14 Remove the top-cover assembly and LCD control-panel module (1 of 3) 1 4. At the rear and on the right side of the product, remove three screws (callout 1). Figure 1-15 Remove the top-cover assembly and LCD control-panel module (2 of 3) 1 ENWW Removal and replacement procedures 13