7. For a 12-inch display , remove the LCD module. a. Remove the four screws holding the LCD module. b. Lift up the right edge of the LCD module about 90°. c. Using a small flat-blade screwdriver, insert the tip under the narrow end of the flex cable connector—not the wide end—and twist the screwdriver to release the connector from the LCD module. 8. For a 13-inch display , remove the LCD module. a. Close, but don’t latch the display; then lift off the display case. b. Loosen and then pull the flex cable out of the connector. c. Remove four screws, two each, on the right and left edges of the LCD module. Figure 2-6.
Removing the LCD Module HP OmniBook 900 Removal and Replacement 2-11 Screw cover Screw, M3×4mm LCD module LCD flex cable Note: 12-i shown. Fo display, th and moun nch display r a 13-inch e flex cable tings differ. Bumper (oval) Screw, M2.5×5mm Bezel Display case Power cable