Table 2-8. Removing Display Components HP OmniBook 900 Removal and Replacement 2-27 Component Removal Procedures Additional Steps (See figure on page 4-6) Bezel, display Remove the display bezel (see page 2-10). Cable, display flex (12-inch display) Keyboard (page 2-12). Display (page 2-16). LCD module (page 2-10). 1. Unsnap the flex cable tube from the display case. 2. Remove the screw holding the left hinge arm and release the flex cable grounding strap. Reassembly Notes: The grounding strap goes between the left hinge arm and the display case. It is held by the hinge screw. The flex cable wraps around the tube only about 1/2 turn.
Cable, display flex (13-inch display) Keyboard (page 2-12). 1. Remove the left hinge cover. 2. Remove the bezel and display case (see page 2- 10). 3. Disconnect the flex cable from the LCD. 4. Unplug the flex cable from the motherboard. Cable, display power Keyboard (page 2-12). 1. Remove the right hinge cover. 2. Remove the display bezel (see page 2-10). 3. Unplug the power cable from the LCD module wires. 4. Unplug the power cable from the motherboard. Reassembly Notes: Insert the display power cable into the notch in the top case before installing the hinge cover. Case, display (12-inch display) Keyboard (page 2-12). Display (page 2-16). LCD module (page 2-10). 1.
Remove the screws holding the hinge arms, then lift out the hinges. 2. Unsnap the flex cable tube from the display case. Lift out the flex cable. 3. Remove the two screws holding the display latch, then lift out the latch. Reassembly Notes: Install the display latch and other components into the new display case. Case, display (13-inch display) Keyboard (page 2-12). 1. Remove the bezel and display case (see page 2- 10). 2. Remove the two screws holding the display latch, then lift out the latch. Reassembly Notes: Install the display latch and other components into the new display case. Hinge Keyboard (page 2-12). Display (page 2-16). 1. Remove the display bezel (see page 2-10). 2.
12-inch display: Remove the screw holding the hinge arm, then lift out the hinge. 13-inch display: Remove the two screws securing the hinge arm to the LCD module. Reassembly Notes (12-inch display): Insert the hinge fully into the case before installing the screw. Latch, display 1. Remove the display bezel (see page 2-10). 2. Remove the two screws holding the latch, then lift out the latch. LCD module See page 2-10.