3.2 Standard Connection Diagram 3.2 Standard Connection Diagram Connect the drive and peripheral devices as shown in Figure 3.1 . It is possible to run the drive via the digital operator without connecting digital I/O wiring. This section does not discuss drive operation; Refer to Start-Up Programming & Operation on page 51 for instructions on operating the drive. NOTICE: Inadequate branch short circuit protection could result in damage to the drive. Install adequate branch circuit short circuit protection per applicable codes.
The drive is suitable for circuits capable of delivering not more than 30,000 RMS symmetrical amperes, 240 Vac maximum (200 V Class) and 480 Vac maximum (400 V Class). NOTICE: When the input voltage is 440 V or higher or the wiring distance is greater than 100 meters, pay special attention to the motor insulation voltage or use a drive duty motor. Failure to comply could lead to motor insulation breakdown. NOTICE: Do not connect AC control circuit ground to drive enclosure. Improper drive grounding can cause control circuit malfunction. NOTICE: The minimum load for the multi-function relay output MA-MB-MC is 10 mA. Terminals +1, +2, , B1, and B2 are for connecting options.
Never connect power supply lines to these terminals. _ DC reactor (option) Thermal relay (option) Braking resistor (option) 2 MCCB Jumper Cooling fan Motor For single phase 200 V power supply, use R/L1 and S/L2.
s1 r1 - B1 +1 +2 B2 s1 r1 FU FV M 1 MCCB MC t1 J1000 t1 FW Three phase power supply 200 to 240 V S/L2 R/L1 R/L1 S/L2 Main circuit U/T1 U T/L3 T/L3 Control circuit W/T3 V/T2 W V M Forward run/stop S1 2 MCCB THRX OFF ON MC SA Reverse run/stop Ground 10 or less (400 V class) 100 or less (200 V class) MC THRX External fault Option unit connector Thermal relay for motor cooling fan SA Multi-step speed 1 main/aux switch Fault reset DIP switch S1 I V Digital output 250 Vac, 10 mA to 1 A 30 Vdc, 10 mA to 1 A (default setting) MC TRX SA MC MA TRX mA Fault Fault relay MA MB Digital inputs (default setting) Sink 24 V MC SC DIP switch S3 Source Shield ground terminal +V Setting power supply +10.5 max.
20 mA AM Analog monitor output Main speed frequency reference. Multi-function programmable A1 0 to +10 V (20 k ) (0)4 to 20 mA (250 ) + 0 to +10 Vdc (2 mA) - AC Monitor output main circuit terminal shielded line twisted-pair shielded line control terminal Figure 3.1 Drive Standard Connection Diagram (200 V Class Example) Remove the jumper when installing an optional DC reactor. The MC on the input side of the main circuit should open when the thermal relay is triggered. Self-cooled motors do not require separate cooling fan motor wiring. Connected using sequence input signal (S1 to S5) from NPN transistor; Default: sink mode (0 V com).
Use only a +24 V internal power supply in sinking mode; the source mode requires an external power supply Refer to I/O Connections on page 44 . Minimum load: 5 Vdc, 10 mA (reference value). 32 SIEP C710606 33A OYMC AC Drive – J1000 User Manual S S2 3 S S 4 5 2 k A