4.3 The Drive and Programming Modes 4.3 The Drive and Programming Modes The drive functions are divided into two main groups accessible via the Digital LED Operator: Drive Mode: The Drive mode allows motor operation and parameter monitoring. Parameter settings cannot be changed when accessing functions in the Drive Mode ( Table 4.3 ) . Programming Mode: The Programming Mode allows access to setup/adjust, verify parameters. The drive prohibits changes in motor operation such as start/stop when the Digital LED Operator is accessing a function in the Programming Mode. Table 4.3 illustrates the different functions visible as the “Up arrow” is scrolled immediately after powering up the drive.
Note: When b1-08 (Run Command Selection while in Programming Mode) is set to 1 (enabled), the drive can run even if the mode is switched to the programming mode. When setting b1-08 to 0 (disabled), the mode cannot be switched to the programming mode while the drive is running. Table 4.3 Summary of Modes The drive is set to operate in Drive Mode when it is first powered up. Switch between display screens by using the and keys.
Start-Up Programming & Operation 4 SIEP C710606 33A OYMC AC Drive – J1000 User Manual 57 Mode Group Drive Mode Functions (Motor operation and monitoring) Description Frequency Reference Display (Initial power-up state) Forward/Reverse Output Frequency Display Output Current Display Output Voltage Reference Key Press LED Digital Operator Display Monitor Display Verify Function Programming Mode Functions Setup Group Parameters (Changing parameters) All Parameters u Navigating the Drive and Programming Modes Power Up Frequency Reference STOP Default Setting This display screen allows the user to monitor and set the frequency reference while the drive is running.
Refer to The Drive and Programming Modes on page 57. Note: The user can select items to display when the drive is first powered up by setting parameter o1-02. Drive Mode Forward/Reverse : Motor rotates forward. : Motor rotates in reverse. Note: For applications that should not run in reverse (fans, pumps, etc.), set parameter b1-04 = “1” to prohibit the motor from rotating in reverse. This sequence also puts the Switching to reverse: The LED is lit when LOCAL is selected drive in LOCAL mode. Output Frequency Display Monitors the frequency output by the drive. Output Curre nt Display Monitors the output current of the drive.