INTRODUCTION IN-3 INSTALLATION Butt Weld Butt Weld RE-29 BODY PANEL REPLACEMENT Foamed Material Application Areas Butt Weld Body Sealer Body Sealer about 5 mm 1. Before temporarily installing the new parts, apply body sealer to the wheel arch. HINT: 1) Apply body sealer about 5 mm (0.20 in.) from the flange, avoiding any oozing. 2. Temporarily install the new parts and check the fit of the rear door, back door, tail gate and rear combination light. 3. After installing the new parts, apply foamed ma- terials. 2) Apply sealer evenly, about 3 - 4 mm (0.12 - 0.16 in.) in diameter. 3) For other sealing points, refer to section AR.
INSTALLATION DIAGRAM Describes in detail installation of the new parts involving repair by welding and/or cutting, but exclud- ing painting. INSTALLATION GUIDE Provides additional information to more efficiently help you perform the installation. SYMBOLS See page IN-4 . ILLUSTRATION of WELD POINTS Weld method and panel position symbols. See page IN-5 . mm in, 5 0.20