BODY PANEL REPLACEMENT RE-25 INSTALLATION Positioning Tape Braze Braze Body Sealer about 10 mm Do not close the drain hole. Body Sealer Cloth Tape 30 ° Hemming Tool 1. Before temporarily installing the new parts, apply body sealer to the reinforcement, side impact protection beam and back side of the new parts. HINT: 1) Apply sealer evenly about 70 mm (0.39 in.) from the flange and 3 mm (0. 12 in.) in diam- eter to the outer panel and apply just enough sealer for the reinforcement and side impact protection beam to make contact. 2. Bend the flange hem about 30 ° with a hammer and dolly, then fasten tightly with a hemming tool. 2) For other sealing points, refer to section AR. HINT:
1) Perform hemming in three steps, being careful not to warp the panel. 2) If a hemming tool cannot be used, hem with a hammer and dolly. mm in. 10 0.39