agn DIVISION CODE FOR DTC DISPLAY MEANING ORDER OF DETAILED INFORMATION DISPLAYED WHEN "SEEK TRACK UP" SWITCH IS PRESSED (ORDER IS REVERSED WHEN 'SEEK TRACK DOWN' SWITCH IS PRESSED) SYS System check result is displayed Logical address DTC CODE Diagnostic memory check result is displayed. Logical address DTC Sub-code Connection confirmation number Number of times of occurrence (4) Check the trouble area on the DTC list. (5) To return to the service check mode, press the preset switch ''3''. 2.
CLEAR DTC (MAIN AVC-LAN) (a) Clearing an individual DTC from memory (when clearing memory of DTCs detected in the past individually) (1) Press the preset switch ''5'' for 2 seconds or more while ''ECHn'' is displayed in the service check mode or during the detailed information mode. HINT: A ''beep'' sound is emitted once when the DTC memory is completely cleared. When the DTC memory is cleared, only the component code (physical address) is displayed for the target component. To check DTCs, press the preset switch ''1'' and perform the service check again.
(b) Clearing the entire DTC memory (when clearing memory of all DTCs detected in the past) (1) Start the diagnostic mode after repairing the trouble area. (2) Press the preset switch ''5'' for 2 seconds or more (''CLR'' is displayed at this time). HINT: A ''beep'' sound is emitted once when the DTC memory is completely cleared. When the DTC memory for all components is cleared, only the component codes (physical addresses) are displayed. cardi