LOGICAL ADDRESS 01 DTC DIAGNOSIS ITEM NO Response to DIAGNOSIS CONTENT No response is identified when changing mode (audio and COUNTERMEASURE AND INSPECTED PARTS Check harness for power supply system of component shown by auxiliary code. agn (Communication Control) DA ON / OFF Instruction visual mode change). Detected when sound and picture does not change by button operation. Check harness for communication system of component shown by auxiliary code. If error occurs again, replace component shown by auxiliary code. 01 *1 (Communication Control) DB Mode status Error Dual alarm is detected. Check harness for power supply system of component shown by auxiliary code.
Check harness for communication system of component shown by auxiliary code. 01 *3 (Communication Control) DC Transmission Error Transmission to component shown by auxiliary code has been failed. (Detecting this DTC does not necessarily mean actual failure.) If same auxiliary code is recorded in other component, check harness for power supply and communication system of components shown by sub code. 01 *2 (Communication Control) DD Master Reset (Momentary Interruption) After engine is started, radio receiver assembly was disconnected from system. If this error occurs frequently, replace radio receiver assembly.
01 *2 (Communication Control) DE Slave Reset (Momentary Interruption) After engine is started, slave component was disconnected from system. Check harness for power supply of component shown by auxiliary code. Check harness or communication system of component shown by auxiliary code. 01 *3 (Communication Control) DF Master Error Due to defective of radio receiver assembly, master function is switched to audio equipment. Error occurs in communication between sub-master (audio) and radio receiver assembly. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly.
Check harness for communication system between radio receiver assembly and sub- master component. 01 (Communication Control) E0 Registration Completion Instruction Error "Registration Completion Instruction" command from radio receiver assembly cannot be received. Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. 01 *1 (Communication Control) E1 Audio processor ON error While source equipment is operating, AMP output is stopped. Check harness for power supply of radio receiver assembly. Check harness for communication of radio receiver assembly.
01 (Communication Control) E2 ON / OFF Instruction Parameter Request Transmission Error occurs in ON / OFF controlling command from radio receiver assembly. Replace radio receiver assembly. 01 (Communication Control) E3 Registration Request Transmission Registration Request command is output from slave component. Receiving Connection Check Instruction, Registration Request command is output from sub-master component. Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. 01 (Communication Control) E4 Plural Frame Abort Plural frame transmission is aborted.
Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. 60 (Radio receiver assembly) 43 AM Tuner Error Abnormal condition is detected in AM tuner. Inspect radio receiver assembly. Replace radio receiver assembly. 60 (Radio receiver assembly) 44 FM Tuner Error Abnormal condition is detected in FM tuner. Replace radio receiver assembly. 61 (Cassette switch) 40 Mechanical or Media Error Malfunction due to mechanical failure is identified. Or, cassette tape is cut or entangled. Inspect cassette tape. 61 (Cassette EJECT cardi