cardiagn.com HINT: Immediately after pressing the mode select switch, the LED goes off activating the non-glare-proof mode. However, when the switch remains pressed, the LED is lit again after 3 seconds and the system enters the automatic glare-proof mode. Continuing to press the mode select switch for 3 seconds after selection of the compass display mode will activate the zone setting mode, showing a number (1-15) on the compass display. (g) ZONE SETTING MODE Pressing the mode select switch for 6 seconds from the normal mode will activate the zone setting mode, showing a number (1-15) on the compass display. HINT: In the initial status, "8" is displayed.
(1) The display number increases by 1 every time the mode select switch is pressed. Referring to the map, check the number for the area where the vehicle will be used and set the zone number. (2) Leave it untouched several seconds after setting and check that the compass display shows an azimuthal direction (N, NE, E, SE, S, SW, W, or NW) or "C". (h) CALIBRATION SETTING MODE (1) After the set zone is displayed, if the switch remains pressed another 3 seconds, it will activate the calibration setting mode. (2) Pressing the switch for 9 seconds from the normal mode will also activate this mode. (3) Drive the vehicle at a slow speed of 8 km/h (5 mph) or less in a circular direction.
(4) Driving the vehicle in a circle 1 to 3 times will display an azimuthal direction on the display, completing the calibration. HINT: Once calibration is completed, it is not necessary to perform the above procedures unless the magnetic field strength is drastically changed. If this happens, the azimuthal display will change to "C".