18 N·m {180 kgf·cm, 13ft·lbf} 8. INSTALL POWER STEERING GEAR HOUSING OIL SEAL 9. INSTALL RACK GUIDE SUB-ASSEMBLY, RACK GUIDE SPRING AND RACK GUIDE SPRING CAP (a) Apply sealant to 2 or 3 threads of the cap. Sealant: Toyota Genuine Adhesive 1344, Three Bond 1344 or Equivalent (b) Temporarily install the cap. 10. ADJUST TOTAL PRELOAD (a) To prevent the steering rack teeth from damaging the oil seal lip, temporarily install the RH and LH rack ends. (b) Torque the rack guide spring cap. Torque: 25 N·m {250 kgf·cm, 18ft·lbf} (c) Return the cap 19°. gn (d) Using SST, turn the control valve shaft right and left 1 or 2 times. SST:
09616-00011 (e) Loosen the cap until the rack guide spring is not functioning. (f) Using SST and a torque wrench, tighten the cap until the preload is within specification. SST: 09616-00011 Preload (turning): Center area 1.8 to 2.2 (18.4 to 22.4 kgf*cm, 16.0 to 19.5 in.*lbf) End area 1.3 to 1.7 (13.3 to 17.3 kgf*cm, 11.5 to 15.0 in.*lbf) 11. INSTALL RACK GUIDE SPRING CAP LOCK NUT (a) Apply sealant to 2 or 3 threads of the nut. Sealant: Toyota Genuine Adhesive 1344, Three Bond 1344 or Equivalent (b) Holding the rack guide spring cap rotating, and using SST, torque the nut. SST: 09922-10010 Torque: 52 N·m {520 kgf·cm, 38ft·lbf} NOTICE:
Use SST 09922-10010 in the direction shown in the illustration. HINT: Use a torque wrench with a fulcrum length of 345 mm (14.97 in.). (c) Recheck the total preload. Standard preload (turning): Center area 1.8 to 2.2 (18.4 to 22.4 kgf*cm, 16.0 to 19.5 in.*lbf) End area cardia