In–36 – Introduction General Information 8. Heated Oxygen Sensor Monitor (Front and rear heated oxygen sensor equipped) Once Twice 3 times 10 times 40 km/h (25 mph) and 900 rpm or more Idling IG SW off 2 min. or more 40 sec. or more 50 sec. or more 50 sec. or more 40 sec. or more 40 sec. or more 50 sec. or more 50 sec. or more A18913 Preconditions The monitor will not run unless: MIL is OFF Drive Pattern (a) Connect the OBD II scan tool to the DLC3 to check monitor status and preconditions. (b) Start the engine and allow to idle for 2 minutes or more. (c) Drive vehicle at 25 mph (40 km/h) or more for at least 50 seconds. (d) Stop vehicle and allow engine to idle for 40 seconds or more.
(e) Perform steps ”c” and ”e” ten times. (f) If readiness status does not switch to complete, ensure preconditions are met, turn ignition off and then repeat steps ”a” through ”e”. 1996–2003 ADDITION OF OBD (OTH021U) 36 Author : Date: