IN−20 − INTRODUCTION FOR ALL OF VEHICLES HINT: Sudden shifting, braking, acceleration or deceleration is not allowed. Do not forget to change the Vehicle Skid Control (VSC) & Traction Control (TRAC) system to operational condition after the test. Check that the VSC warning indicator light goes off when restarting the engine. (d) On−Vehicle Wheel Balancing: When doing on−vehicle wheel balancing on a full−time 4WD vehicle, to prevent each wheel from being rotated at different speed in different directions (which could dam- age the center differential), always be sure to observe the following precautions. (1) All of 4 wheels should be jacked up, being apart from the ground completely.
(2) Put the center differential in LOCK position. (3) Prohibit the Vehicle Skid Control (VSC) & Traction Control (TRAC) system from the activation (See step 2.). (4) The parking brake lever should be fully released. (5) None of the brakes should be applied. (6) The wheels should be driven on the wheel balancer with the engine running. (7) Carry out the wheel balancing with the transmission position in D. HINT: When doing this balancing, pay attention to the other wheels rotating at the same time. Sudden acceleration, deceleration or braking is not al- lowed. Do not forget to change the Vehicle Skid Control (VSC) & Traction Control (TRAC) system to operational condition after the test.
Check that the VSC warning indicator light goes off when restarting the engine. B04218 2000 LEXUS LX470 (RM745U) 20 Author : Date: