7. REMOVE FRONT DOOR COURTESY LIGHT ASSEMBLY (a) Using a screwdriver, remove the door courtesy light, and then disconnect the connector. HINT: Tape the screwdriver tip before use. gn 8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (a) Remove the 2 caps and 7 screws. (b) Remove the 3 clips. (c) Insert a screwdriver between the door and the door trim to pry the trim. NOTICE: Be careful not to damage the door and the door trim. HINT: Tape the screwdriver tip before use. (d) Pull the trim upward to remove it. 9. REMOVE SEAT MEMORY SWITCH (a) Using screwdriver, remove the seat memory switch. HINT: Tape the screwdriver tip before use. (b) Disconnect the connector. 10.
REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY (a) Remove the screw and inside handle. (b) Disconnect the 2 control cables from the inside handle as shown in the illustration. 11. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (a) Disconnect the connector, and then remove the bolt and the front no. 2 speaker. 12. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY (a) Disconnect the connector, and then remove the 3 bolts and outside rear view mirror. 13. REMOVE FRONT DOOR SERVICE HOLE COVER (a) Remove the clamps and wire harness. (b) Remove the service hole cover. NOTICE: Do not tear the cover. HINT: At the time of reassembly, pull out the 2 control cables and wire harness through the service hole cover. 14.
REMOVE FRONT DOOR BELT MOULDING ASSEMBLY (a) Remove the screw. (b) Using a scraper, remove the door belt moulding. HINT: Tape the screwdriver tip before use. 15. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY (a) Open the door glass until the bolts appear in the service hole. cardia