MC-909 Press the [F6] button to proceed to the all-pixel-on test. The LCD display will show as follows. 17. Factory Reset fig.test153_70 The settings of the MC-909 differ depending on the destination region. There are three possible settings, as follows. The order of the preset patterns will differ according to the destination region. "100V": P001 R&B 1, P002 Euro Trance 1, P003 Garage 1, P004 Minimal 1, P005 G-Funk 1 "117V": P001 R&B 1, P002 Euro Trance 1, P003 Garage 1, P004 Minimal 1, P005 G-Funk 1 "230V,240V":
P001 R&B 1, P002 Euro Trance 1, P003 Garage 1, P004 Minimal 1, P005 G-Funk 1 If the destination region is already set, the LCD display will show as follows, and factory reset will be executed automatically. fig.117f Verify that there are no missing pixels or inconsistency in darkness. Press the [F6] button to proceed to the all-pixel-off test. The LCD display will show as follows. fig.test154_70 Verify that the lower left of the LCD display shows as follows. Voltage area display 117V U or 117V U/CS: 117V 230V EU,230V E or 240V A:
230/240V If the display shows other than your voltage area, refer to the procedure for changing the destination region, and change it to "100V." When factory reset is completed, the LCD display will show as follows, and you will exit Test mode. fig.117c Verify that there is no obtrusive dirt or dust. Press the [F6] button to proceed to the next test item. 16. USB test This tests USB operation. When you enter the USB test, the LCD display will show as follows. fig.test161_70 Voltage area :117V U or 117V U/CS Connect the USB cable to a computer (with USB connector; OS must be Windows Me, Windows 2000, or Windows XP). If the test result is OK, the display will indicate “Status:
Connect USB Test Completed!” On your computer, use the Eject Device button shown in the taskbar in the lower right of the screen to cancel the connection with the MC-909. Press the [F6] button to proceed to the next test item. 29