Care & Maintenance Brush * Weekly cleaning is recommended Omnidirectional Wheel * Clean it as needed 1. Flip the vacuum-mop over and pinch the clips to remove the brush cover. 2. Lift the brush out of the vacuum-mop, then clean the brush bearings. 3. Use the included brush cleaning tool to remove any hairs tangled on the brush. 4. Reinsert the brush, then put the cover back on and press on it until the clips lock into place. Wheel Axle 1. Flip the vacuum-mop over and pull out the omnidirectional wheel. 2. Remove hair, dirt, and other debris from the wheel and axle. 3. Reinsert the wheel and press it firmly back into place. Brush Cover Clips Brush Brush Bearings Notes:
· A small screwdriver or other pry tool can be used to gently pop out and remove the wheel. · The wheel can be cleaned with water and reinstalled after drying. Brush Cleaning Tool Notes: · If too much hair is tangled in the brush, or if the hair is tightly tangled, do not forcibly pull on it, as this could damage the brush. · It is recommended to clean the brush weekly and replaced every 6 to 12 months. 12