Removal Procedure 1. Unplug the ac adapter, if present, and remove the battery. 2. Remove the hard disk drive (see page 2-5). 3. Slide open the RAM cover about 3 mm, then lift off the cover. Note For an OmniBook 3000, if the RAM cover does not have a Mylar insulator on the inside, replace the cover with a new one. (Service note 3000-07.) RAM Cover 4. Release the two metal latches at the sides of the RAM board, so the free edge of the board pops up. Figure 2-5. Removing the RAM Cover 5. Pull the board out of the connector. For an OmniBook 2100/3100 with a Pentium processor, no more than 32 MB is supported in this slot. Figure 2-6.
Removing a RAM Board Reassembly Notes • Insert the RAM board into the connector at about a 30° angle until it is fully inserted. Then press down at both sides until both latches snap closed. • Place the RAM cover about 3 mm from its closed position, then slide it closed. 2-8 Removal and Replacement HP OmniBook 2100/3000/3100 Note: Some OmniBook 2100 have only one RAM slo /3100s t.