Making Connections Using OmniBook Plug-In Modules Using OmniBook Plug-In Modules The plug-in module bay can hold a DVD / floppy disk drive, a CD-ROM / floppy disk drive, an LS-120 drive, a second battery, or a second hard disk drive. This documentation describes the module that shipped with the OmniBook—the DVD / floppy disk drive or the CD-ROM / floppy disk drive. If you’ve purchased other accessory modules, refer to the accessory documentation that accompanied them for instructions. This section describes how to ♦ Install hot-swap support. ♦ Replace a plug-in module. ♦ Insert or eject a floppy disk. ♦ Insert or remove a DVD or a CD.
To install hot-swap support The Agatй Tioman "hot-swap" software for Windows 95 and Windows 98 is loaded on the hard disk, but it is not installed. If you install this software, you can switch most modules in the plug-in bay without shutting down the computer and rebooting. (This software does not support Windows NT.) • Click Start, Programs, Agatй Tioman for HP, Setup, then follow the onscreen instructions. 4-3