J Ceiling cassette −2 way− (FDTW) J Wall mounted (FDK) 1. Push one side of the inlet panel (pin A side) upward. 4. Press the air filter and turn the stopper to remove the air filter. 1. Pull up the suction grille forward. Hold the concave sections at both the righit and left side with your hands and pull the suction grille forward. It stops while being open at about 60 ° . 2. Lightly hold the handle of the air filter , slightly lift it upward, and then pull it out forward. 2. Disengage the panel from pin A. 3. Disengage the panel from the pin B and remove the panel. e Disengage the pin B side. Stopper c Push the pin A side upward. d Disengage the pin A side.
Pin B Pin A Turn J Floor standing -2way- (FDFW) Panel Number of stoppers FDTW 28 - 71 6pc. FDTW 90-140 10pc. Caution J Ceiling cassette −4 way Compact (600 x 600 mm)− (FDTC) Install the air filter in the correct order. Open Place fingers at the recesses on both sides of the panel and pull down the panel forward so that it will be open by about 15°. Close Push both ends evenly and press further lightly at the center. Remove When removing the panel for internal cleaning or others, open the panel, remove the string and then pull it forward. Install Secure the upper edge of the panel by lightly pushing it in, place the string as illustrated and then close the panel. 1.
Slide the inlet grille levers in the direction of the arrow ( ), and open it downwards. Hooks Hooks 2. Turn the inlet grille stopper. 3. Pull the filter toward you. 4. When the filter is put in place, insert the filter into the hooks on the inlet grille, and be sure to return the stopper to its original position. Stopper 5. When putting the inlet grille back in place, slide the levers in the opposite direction and check to be sure that the grille does not come open. Remove 1. Pull up the air inlet panel forwards. 2. Lightly hold the knobs at the both sides and lift a little to remove the panel forward. Install 1. Hold firmly the filter at the both sides as shown at right and insert securely.
2. Close the air inlet panel. J Ceiling suspended (FDE) When mounting, press the lever forward untill it snaps. When morrting, snab the filter into the tabs of inlet grille. Air filter tabs J Ceiling cassette −1 way− (FDTS) J Floor standing (with casing) (FDFL) J Floor standing (without casing) (FDFU) 1. Slide the lever of the suction grille in the arrow ( ) direction to open the grille. 2. While light pushing up, remove the filter from the tabs at the left and righit, and pull towards the front . Remove the front panel and pull the air filter out from the bottom of the unit. Pull the air filter out from the bottom of the unit.
Air filter Tab Suction grille Tabs J Duct connected −High static pressure− (FDU) J Duct connected −Middle static pressure− (FDUM) J Duct connected (Ultra thin) −Low static pressure− (FDQS) J Duct connected −Compact & Flexible− (FDUH) J Duct connected −High static pressure Out door Air processing unit (FDU -F) J Duct connected −Low static pressure− (FDUT) J Ceiling cassette −1 way compact− (FDTQ) Air filter is attached when the air conditioner is installed, so consult your dealer about how to remove or clean it. Tab Suction grille Tabs 17 HOW TO MAINTAIN HOW TO MAINTAIN 1. Slide the lever of the inlet grille backward ( direction) and open it downwards. 2.
Pressing the inlet grille, press the filter to remove it from the tab and pull it downwards. 1. Slide the lever of the suction grille in the arrow ( ) direction to open the grille. 2. While light pushing up, remove the filter from the tabs at the left and righit, and pull towards the front. Air filter