Before Starting Maintenance Work Machine Status During Maintenance Work To ensure that maintenance work is done safely, for step 1 of each procedure, check that the machine is in the indicated status. The following explains each status and the procedure to put the machine in that status. Power Off Status The machine's main power switch is in 0 (OFF) and the power is off. Work which involves touching or entering 10 the machine's operating parts is done in this status. If the machine's power is on, turn the power off using the following procedure. 1 Press the emergency stop button. 2 Close the Leonardo screen and shut down the control PC.
3 Turn the main power switch to 0 (OFF) to turn the power off. When performing maintenance after finishing a day's printing work, refer to "Workflow When Turning Off the Power" in the "Operation Guide". Printing Standby Status The machine's power is on, Leonardo has been started, and printing is possible. Green on the tower lamp is lit up. Operations performed after moving the machine's operating parts (print head carriage, etc.) are started from this status. If the machine is not in the Printing Standby Status, perform the following procedure. If the machine's power is off: Turn on the power and then execute Set point.
Refer to "Workflow before Beginning Work" in the "Operation Guide" for details. If the machine's power is on but it is not in Printing Standby Status: Execute Set point using the following procedure. When performing maintenance after finishing a day's printing work, refer to "Workflow When Turning Off the Power" in the "Operation Guide".