English en Operating the appliance Thoroughly clean the mincer before using for the first time, see “Cleaning and care”. Important information In these instructions for use the recom- mended reference values for the operating speed refer to appliances with a 7-setting rotary switch. For appliances with a 4-setting rotary switch you can find the values in brackets after the values for a 7-setting rotary switch. ■ Assemble mincer attachment in the indicated sequence (Fig. A ) . Do not fully tighten threaded ring. ■ Insert seal. Note position (Fig. C ) ! Figure D : ■ Press the Release button and move the swivel arm to position 4 . ■ Connect mincer to the drive.
Note position of the driver (1d) with respect to the drive. If required, turn the driver slightly. To do this, the threaded ring must not be screwed tightly! ■ Turn mincer anti-clockwise. ■ Press down locking lever. ■ Now tighten the threaded ring. ■ Attach filler tray. ■ Place a bowl or plate under the outlet opening. ■ Insert the mains plug. ■ Set rotary knob to setting 7 (4). ■ Place the food to be processed in the filling tray. ■ Use the pusher to push in ingredients. W Warning! do not process bones. Tip: Process steak tartare through the mincer twice. Cleaning and servicing Attention! Do not use abrasive cleaning agents. Surfaces may be damaged.
Mincer and individual parts are not dishwasher-proof. ■ Loosen threaded ring and disassemble attachment. ■ Rinse individual parts by hand and dry immediately. Optional accessories (available from dealers) W Warning! Always assemble the accessories without blades and perforated discs. Follow all instructions mentioned above concerning “For your safety”, “After work” or “Cleaning and Servicing”. Fruit press attachment for pressing e.g. berries, tomatoes, apples, pears, rosehips (cook rosehips for 1 hour before pressing). Extracted fruit pulp is especially suitable for making jam. Figure E : ■ Preparation as described for mincer attachment.
Note required individual parts and sequence when assembling the fruit press attachment. ■ First undo the fastening screw as far as is required to allow the pulp to flow out while still moist. ■ Then adjust the fastening screw until the pulp flows out with the required moisture. ■ Place the food to be processed in the filling tray. Use the pusher to push in ingredients. ■ Set rotary knob to setting 7 (4). After using the appliance ■ Switch off the appliance with the rotary switch. ■ Lift up locking lever. ■ Rotate the mincer in a clockwise direc- tion and remove. ■ Clean mincer. 7 MUZ5FW1_for_MUM582578001019164.indb 7 22.06.2015 11:55:08