２ - ３ - ６ Changing the State of the Button Object In the NA series, states of a Button object can only be changed when it is pressed down. Thus, it does not have the same function of state change by an address as the NS series does. To make the behaviors of the Button objects equivalent to those of the NS series, you must combine the Button object with a Lamp object. Changing the State by Turning ON/OFF the Write Address This is equivalent to Type 1 Buttons in the NS series. The state is not changed when pressed down, but changed when turning ON or OFF the write address. 22 1. Select the [Toolbox] tab. On the tab page, select [Lamps] – [Bit Lamp], then drag and drop it to the page.
tab page, select [Lamps] – [Bit Lamp], then drag and drop it to the page. 2. Select the Bit Lamp and open the [Properties] tab page. Specify [Appearance] and [Layout] arbitrarily. At the same time, specify the condition to change the state (i.e. the write address as defined in the NS series). 3. Select the [Toolbox] tab. On the tab page, select [Buttons] – [Momentary Button], then drag and drop it to the page. (Select a Toggle Button if you need toggle operation, or a Set Button for set operation. You can select a button to create depending on the function.)