An explanation of the communication parameter specifications and cable wiring. Note If you wish to use communication settings other than those described in this chapter, you must also change the program used. For more information on the program, please refer to "9. Program". The Following are the Serial Communication Settings. * SCU Unit:
Serial Communications Unit Precautions for Correct Use It is assumed that the serial communication unit used is "CJ1W-SCU22", the unit number is "0", the communication (connection) port is "port 2" and these have been set ahead of time.When connecting under conditions other than this, refer to Section 9 “Program" and change the control data of the assigned Relay Area and PMCR Instruction to create a program. 8 6. Serial Communication Settings 6.1.
Configuring the Serial Communication Settings Parameter (Setting) SCU Unit * Smart camera Unit Number 0 - Connection Port Port 2 (RS-232C) - Serial Communication Mode Protocol Macro - Data Bits 8 bit 8 bit (default) Stop Bits 1 bit 1 bit (default) Parity No None (Default) Baud Rate 115,200bps 115,200Bps (default) Protocol macro transmission method Full Duplex - Header - None (default) Footer -