Note Refer to Chapter 5 "Controller Configurations and Setup" in the "Sysmac Studio Version 1.0 Operation Manual" (W504) for details on online connection to the controller. 27 7 The Confirmation dialog shown on the right will be displayed. Click [Yes]. * The dialog that is displayed differs depending on the status of the controller you are using, but make the selection to proceed with processing. * The Serial ID displayed differs by device used. 8 When you are online, a yellow frame will be displayed in the upper part of the [Edit window]. 9 From the Menu Bar, select [Controller] – [Synchronization]. 10 The [Synchronization] dialog opens.
Make sure that the data you want to transfer (in the right figure, [NJ501]) is checked, and click [Transfer to Controller]. * Executing [Transfer to Controller] transfers the Sysmac Studio Project data to the controller and checks that the data was received.