This example shows a general precaution for something that you must do. This document describes the procedures for connecting the Omron smart camera (F430-F Series) to the NJ Series Machine Automation Controller (hereinafter referred to as Controller) via serial communications and for verifying the serial connection. Refer to Section 6. EtherNet/IP Settings and Section 7. EtherNet/IP Connection Procedure to understand setting methods and key points for setting up Serial Communications.
Using the user program in the "CX-Programmer Project File" and the protocol data in the "CX-Protocol Project File" prepared in advance, use the "Measurement trigger" command for the smart camera to check the serial communication connection. Obtain the Sysmac Studio project file in advance before proceeding. Contact Omron for information on how to obtain this file. The purpose of this document is to explain the wiring method, the communication settings required for connection of the devices and the step by step setting procedure.
The program included with the document was created using the same procedures and can be used to confirm that all the settings have been made correctly and that a connection can be established (Confirm Connection). It is not a program created on the premise of constant use in the field, so its functionality and performance aspects have not been fully considered. When building an actual system, it is necessary to refer to the wiring method and communication setting contents and setting procedures described in this document, and to design a new program according to the customer's purpose for the program. 4 4. Overview Name Filename Version Sysmac Studio Project File (Extension:
smc2) OMRON F430 NJ PMCR232C V100.smc2 _ _ _ _ Ver.1.00 CX-Protocol Project File (extension: psw) OMRON F430 NJ PMCR232C V100.psw _ _ _ _ Ver.1.00