3.2.2. Importing the Code into the Sysmac Studio You import the code outputted by the Simulink PLC Coder into the Sysmac Studio. Additional Information Refer to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504) for how to use the Sysmac Studio. 25 1 Start the Sysmac Studio and create a new project. Set the Select Device Area as shown below. Category: Controller Device: NJ501-1300 Version: 1.09 2 Delete the Program0 that is automatically created when a new project is created because it is not used in this Guide.